Impact Series Multi-Gas Detectors

Using high specification flammable, Oxygen and patented Surecell™ toxic sensors, our unique cartridge technology ensures safe, accurate and reliable measurements are always made.

Available in two configurations, the Impact and Impact Pro accepts either disposable and/or serviceable cartridges respectively, all of which are pre-calibrated and can be replaced in under one minute, simplifying maintenance and minimizing cost wherever possible. Compact and rugged, these monitors are designed for tough working environments while being small, lightweight and unobtrusive, making them ideal for use in confined spaces where entry and exit may be difficult.

Reliable Operation

Reliable operation with patented SurecellTM toxic sensors
On screen prompts guide user
Rugged and impact resistant
Pre-calibrated plug-in sensor cartridge
High specification sensors
Patented Surecell™ toxic sensors
Stable and accurate

Easy to Use

One button on/off
Multi-lingual, intuitive menu system
On screen prompts guide user
Built-in correction factors for flammable gases
Minimal training required
Plug-in operation for all serviceable parts
Cartridge replacement in less than one minute
Re-calibration in less than two minutes when using Enforcer
Minimized cost of ownership

Durable Housing

Waterproof to IP67
Rugged and impact resistant
Built for everyday use

Alarm Indication

3 levels of instantaneous alarm, time weighted average alarms on toxic
Periodic confidence flash and bleep
Increasingly rapid flashing, ultra-bright alarm LEDs
Powerful two tone audible alarm
Vibrating alarm for noisy environments*
Safelink communications*

User Friendly Pre-entry Check

Peak hold function and drop line
Hand aspiration
Built-in automatic pump*
Totally flexible

Accessories

Enforcer Bump Test / Calibration Kit

The Enforcer calibrates Impact multi-gas detectors fitted with oxygen, combustible, carbon monoxide and hydrogen sulfide sensors in less than two minutes — and can also perform low-level oxygen tests. Volumes and flow rates are minimized to allow approximately 200 calibrations per cylinder of gas, making calibration as low in cost as a bump test.